My Laser Scepter - Build Picture 4
Laser Scepter

Back to the Burning Man Page

This picture shows the external heatsink after sweat soldering. The ID is where the water flows, the C'Bore is an O-Ring surface to seal the heatsink to the internal heatsink. The stainless steel parts are used to clamp the flange, compressing the O-Ring, forming the seal between the inner and outer heatsinks. The T shaped piece at the top is the inlet to fill the heatsink with water once it is all assembled.



All contents of this site are Copyright © 1999-2016 Marks Custom Stuff All rights reserved.